OrcaSlicer 3D Printer Calibration Features Deep Dive Obico Knowledge

Prime Tower Orca Slicer. Orca Slicer getting started guide A slicer for all of your 3D printers The Prime Tower have an hard limit to move and stop 15mm away to any border of the print area in the bed Have used this setup with previous versions of orca without issue

I have already managed to change the filament correctly with a pyrga tower, the only detail is that I cannot find a way to remove the additional purge, since it makes an extrusion on top of the purge tower, how can I remove that additional extrusion ? Orca bot: this issue is stale because it has been open for 90.

Orca Slicer 1.63 released Orca 3DDruck Forum

You don't need to use a prime tower if you're doing a manual filament change Change tower Width to 10 (which seems reasonable) and re-slice Orca bot: this issue is stale because it has been open for 90.

Orca Slicer Quick and easy support settings YouTube. Yes you can use the prime tower only but you do have to add 2 or more filaments so the prime tower will show up on the bed and yes you can move the prime tower to your seam location I have already managed to change the filament correctly with a pyrga tower, the only detail is that I cannot find a way to remove the additional purge, since it makes an extrusion on top of the purge tower, how can I remove that additional extrusion ?

OrcaSlicer Seam Settings How to Use It Obico Knowledge Base. You don't need to use a prime tower if you're doing a manual filament change The Prepare tab does not take in to account the brim width of the Prime tower, but this doesn't should block the movement of the Prime tower.